Homeowners report that painting a home’s exterior costs an average of $2,849 with a typical range between $1,710 and $3,993. The average price per square foot ranges from $0.50 to $3.50 depending on your location, condition of your exterior and accessibility. Stucco and brick cost an average of $1 per square foot more than vinyl or wood. The average 2,500 square feet home costs an average of $4,000, though it can range from $1,250 to $8,750.
A thorough scrubbing is a must before painting any exterior surface. It removes the dirt and broken-down paint residues that keep fresh coats from adhering and gets rid of mildew that grows on paint in all but the most arid climates. Most contractors clean with pressure washers, but in the hands of someone unfamiliar with the equipment, these can gouge wood, shatter glass, and drive water behind siding and trim. Using a hose, a pump sprayer, and a scrub brush is slower but safer, and just as effective. Arvada Home Painting
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."

Expect to pay between $600 to $3,500 or $1.25 to $3 per square foot to coat vinyl, with prices likely increasing for the finish. It is one of the more inexpensive siding materials to have repainted, especially with recent innovations in materials. Changing the finish on your siding is not recommended unless it's completely degraded and worn away by the weather. You can save nearly half the vinyl siding installation cost of $4 per square foot by painting rather than replacing. Before adding a new coat to vinyl siding, House Painting Arvada
If there is any peeling — and there usually is somewhere — it's essential to scrape off any loose paint. This doesn't just mean the parts that are already separated from the wood and ready to fall off on their own. Each spot where paint has peeled loose needs to be scraped thoroughly until you can no longer get the sharp corner of a putty knife under any of the surrounding edges of paint. Then, the bare spot needs to be sanded until the paint edges are smooth. House Painting Arvada CO
×